IMO it's a waste of a GCX loop using two of them for one unit in mono (unless you were also putting the GSP1101's preamp loop in one of the GCX's loops). You haven't mentioned how you run your GCP- is it 4 Presets/8 IA or 10 Presets per bank? Just need to get this GSP onboard and assign it to preset 2. I'm REALLY close, I have everything else talking and doing what it's supposed to do, I have presets 1, 3, and 4 working the way I want it. Which part of the manual shows the specifics on how to setup say loop 7 where when activated, it not only engages the GSP, but change the midi channel to something specific. So it's as if it bypasses it altogether ** Even if I just activate it from the front/face of the GSP, nothing. I don't get anything but a clear/clean signal. When I activate loop 7, you'd think that whatever I had it set to on the GSP would come through the system. ** As a side note: I connected the GSP just to loop 7. How do I wire up the GSP into loops 7 AND 8? I get how to do it into just one loop. However, I guess to be more specific, how do I do that? In other words: John C - I gave you kudos on the Voodoo Lab Facebook page! Thanks for all your help.

Question 2: Can I change the value with the ground control pro to switch through the midi presets (grab different effects) for these two channels? Question 1: How do I hook the GSP into the GCX to have loop 7 AND 8 be dedicated to the GSP1101? Is there a specific way to wire the in's and out's to get it assigned to both? I'm assuming also I will need the midi jump from midi out on the GCX to the midi in on the GSP1101

Loop 8 - I want to use the Digitech GSP1101 in the rack for a specific effect Loop 7 - I want to use the Digitech GSP1101 in the rack for a specific effect Wireless into Morley Bad Horsie Wah out of there to the 'in' on loop one on GCX I did a search for anything similar to this and didn't find it - so here't goes.

Gsp1101 patches